The Merry-go-round appt/script (?) works with TTS. Lots of inconstant clunky stop and go but the train runs each of the eight TrainThing paths, semaphores go up and down and the Laptop talks about what's happening. Before I build the next TrainThing video to show off signals, audio and computer driven trains, I need to:
With the board up:
Install the last semaphore.
Manufacture two more post for the servo bracket.
Fix some of the signals that don't seem to work.
Sensor 36 doesn't seem to work. Haven't figured out why.
With the board back down:
Fine tune, adjust the three aspect/angle of each semaphore arm.
Try to cleanup some of the clunky timing.
Adjust order of train movement and signals so signal is green/yellow before train moves, and red afterwards.
(?) Add dwarf signals to the beginning/end of the script.
Minor update to CSS HTML Validator Pro.
And of course another Arduino failed! This is the third. They all seem to fail in the same way. Need to contact tech support and see what is going on.